EdenPURE 1000 Replacement Parts:
The Original EdenPURE Model 1000 was manufactured at three different locations
in Asia. There are some slight variations in parts used at each location.
Some EdenPURE Replacement Parts such as the heating elements or bulbs are
standard and do not vary between manufacturers. Other EdenPURE Replacement Parts such as
sensors and body panels do. You can identify which location your EdenPURE Model 1000 was manufactured at by looking on the product label located on the back of the heater.
EdenPURE Replacement Parts for units that say "Manufacturer: Sunway" on the rear product label
click here.
EdenPURE Replacement Parts for units that say "Manufacturer:
Well" on the rear product label
click here.
EdenPURE Replacement Parts for units that say "Manufacturer:
Youlong" on the rear product label
click here.
EdenPURE 1000 Heater Tips:
Thinking about breathing some new life into your old
EdenPURE? For starters make sure that you select the proper manufacturer of your
unit. The most common replacment part for the original EdenPURE 1000 heaters is
of course the heating elements. There are 6 quartz infrared tubes located inside
your unit. 5 short and one long tube are in each. The longer 6th tube may not be
initially visible, but is located in the lower front of the heater. These tubes
were initially designed for about 3 years of good use. The newer heating
elements are rated about 4 times as long. We don't recommend trying to replace
just one or two, you should replace them in a complete set for the best
performance. The replacement bulbs are black in color, so you may not see that
familiar glow, but you will notice a large increase in heat output. Also we
don't recommend trying to splice the wires with regular wire nuts. We offer
replacement connectors that are designed to work with your unit and are safer to
use. You should also consider replacing the filter. After many years of use, it
becomes more difficult for air to pass through them.
|
